BMW F-Chassis Auto StartStop Permanent Off Coding by Launch X431 PAD VII

This post comes with the tutorial of Auto Start/Stop Permanent Off Coding for BMW F-Chassis by using Launch X431 Pad VII.

Here is the specific procedure:

In the main menu, select Local Diagnose
BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-1

Then select European>> BMW
Read vehicle version info and click OK
Select Automatically Search
Confirm the vehicle info and click NEXT

BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-2

Then you can see if the car module is normal
In System Topology, it shows the ZGM is abnormal

BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-3

In System list, there is a fault in the ZGM (Central Gateway Module), it is CD0487 ZGM: Synchronisation Process for flexRay failed

BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-4

After this procedure finishes, there may still be a warning light or fault code displayed until the vehicle has completed a road test, and the ignition switch off for 10 seconds and on.

Make sure no DTC
Next step is to do Start/Stop Permanent Off Coding:
Click Coding/Program
Select Personalization
Confirm the vehicle info again and click NEXT
Getting the vehicle detailed configuration info…
Select CAS (Car Access System – CAS/FEM/BDC)>> Function selection

Read the operation tips carefully
1. To avoid data loss due to improper operation, firstly select backup data function
2. If a problem occurs, you can choose to restore the data function. You can also encode it to restore the default state

BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-5
BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-6

Auto Start& Stop memorized last state and Switch off auto start & stop by default are disabled, click the drop-down button to change them to enabled

BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-7
BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-8

Recoding has been completed

BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-9

Finally, back to the main menu and select automatically search again

Now you can see all modules are normal, there is no fault code.

BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-10
BMW-F-Chassis-Auto-StartStop-Permanent-Off-Coding-by-Launch-X431-PAD-VII-11

Done!

 

Be the first to comment

Leave a Reply

Your email address will not be published.


*