Mitsubishi ECU Reprogramming by MUT-III Diagnostics

In this post, Obd2tool.com show you guide on how to use MUT-III diagnostic software to do ECM reprogramming for Mitsubishi Lancer 2008. More post for Mitsubishi,please refer to Mitsubishi Trouble Repair

Mitsubishi-ECU-Reprogramming-by-MUT-III-Diagnostics-1

Preparations:

2020 MUT-3 MUT-III Mitsubishi Diagnostic Software Free Download

MUT-III Diagnostic interface

Procedures:

Connect Openport 2.0 adapter to Mitsubishi Lancer obd port

Then run MUT-III software,select “STV”

Mitsubishi-ECU-Reprogramming-by-MUT-III-Diagnostics-2

Click “ECU programming” button

Mitsubishi-ECU-Reprogramming-by-MUT-III-Diagnostics-3

Click “ECU Reprogramming”

Mitsubishi-ECU-Reprogramming-by-MUT-III-Diagnostics-4

Select “ETACS”,”Can’t see P/N on ECU”

Select data from right side,then click “OK” button to start reprogramming

Mitsubishi-ECU-Reprogramming-by-MUT-III-Diagnostics-5

Now it is performing programming process,just wait

Mitsubishi-ECU-Reprogramming-by-MUT-III-Diagnostics-6

Completed

On-board ECU has been reprogrammed

To finish reprogramming,turn OFF IG switch

Press the OK button to confirm the result of reprogramming

Mitsubishi-ECU-Reprogramming-by-MUT-III-Diagnostics-7

Be the first to comment

Leave a Reply

Your email address will not be published.


*