How to set up Launch X431 V 8 inch tablet WiFi & Bluetooth

How to setup WiFi & Bluetooth in the 2017 Launch X431 V 8 inch scan tool for vehicle diagnosis? Here is the WiFi & Bluetooth setup manual for reference.

Part 1: How to set up Wi-Fi in the Launch X431 V 8 inch scan tool

Note: If you don’t need to use Wi-Fi for a while, you can turn it off to conserve

battery life.

X-431 V has built-in Wi-Fi that can be used to get online. Once you’re online,

you can register your X-431 V, browse the Internet, get apps, send email and

check for software updates.

Connect to a Wi-Fi network
On the home screen, tap Settings > WLAN.
Slide the Wi-Fi switch to ON, X-431 V will start searching for available wireless networks.

Select a wireless network,

– If the chosen network is open, X-431 V will connect automatically;

– If the selected network is encrypted, a network password will need to be entered.

When “Connected” appears, tap the Enter button to exit and return to the home screen.

Note: When Wi-Fi is not required, this should be disabled to conserve battery Power.

Once it is connected successfully, tap the Wi-Fi network from the list to view its name, link speed, security type, IP address etc.

When this tool is in range, it will connect to the previously linked network Automatically.

Disconnect from a Wi-Fi network
On home screen, tap Settings > WLAN.
Tap the network with a Connected status, then tap “Disconnect”

III. Vehicle diagnosis via WiFi

launch-x431-v-8-inch-wifi-diagnosis

Part 2: How to perform Bluetooth setting in the new Launch Scanner X431 V scan tool

Bluetooth setting

Enter X-431 V Bluetooth setting screen (“Settings” –> “Bluetooth”), slide the Bluetooth switch to ON and X-431 V will start searching available Bluetooth device, tap the desired connector to pair.

By default, the Bluetooth name is 98549*****00 (where ***** stands for 5 digits.).

Note: In case no Bluetooth setting is done before diagnostic software is launched, you can also configure it while using the software.

Car diagnosis via Bluetooth

Tap –> “Diagnostic” to enter the vehicle selection page.

Take Demo as an example to demonstrate how to diagnose a vehicle.

1). Tap the “DEMO”, the following dialog box appears:

launch-x431-v-8-inch-bluetooth-diagnosis-1

2). Tap “DEMO” to ignore Bluetooth connection and jump to the DEMO system selection screen. (Note: No Bluetooth connection is required for DEMO program.)

launch-x431-v-8-inch-bluetooth-diagnosis-2

3). Tap “Engine”, the system will jump to the function menu.

launch-x431-v-8-inch-bluetooth-diagnosis-3

Read DTC

launch-x431-v-8-inch-bluetooth-diagnosis-4

Read Data Stream

launch-x431-v-8-inch-bluetooth-diagnosis-5

launch-x431-v-8-inch-bluetooth-diagnosis-6

Also, special functions and reset service are available.

Special functions:

Injector test, fuel pump test, purge control solenoid and so on.

Reset service:

Oil Reset Service, Steering Angle Calibration, Electronic Parking Brake Reset, Battery Register / Battery Maintenance, ABS Bleeding, Electronic Throttle Position Reset / Learn, Diesel Particulate Filter (DPF) Regeneration, Tire Pressure Monitor System Reset

Be the first to comment

Leave a Reply

Your email address will not be published.


*