Tag: Vxdiag Benz C6

oem-clone-xentry-vci-clone-feedback-01 (2)

How to use Benz VCI C6 Mercedes Diagnostic Tool

This article is on how to use Benz VCI C6 Mercedes diagnostic tool. Simple guide: Benz VCI C6 software is frozen by the factory and needs to be activated using teamviewer after receiving the package . After that, plug VCI C6 to the computer and the car, open the software

DTS-settings-01 (2)

VXDIAG C6 – DoIP Fix for DTS Monaco enet cable DTS

I have seen a few people struggling with DoIP and VXDIAG C6. Please see the attached image of the interface settings for DoIP. When using DoIP with Vxdiag make sure you uncheck/turn off the CAN interface(MODULE_TYPE_ID_MTS6532) in DTS. Then connect the interface to the car and laptop, open vxmanager and

vxdiag-benz-c6-vci-cannot-be-used-1 (2)

VXDIAG Benz C6 VCI “Cannot be Used” Solution

Problem: I recently got the Vxdiag Benz C6 XENTRY updated to 2019.05 version.  It connects fine before but the VCI seems not cumminicate well after update. Error “VCI Cannot be Used. Firmware is older than the installed program version” error picture attached: Solution: The old Benz C6 VCI driver is not


How to Do Online Coding on Mercedes W205 with Vxdiag Benz C6 DOIP/ MB STAR C4 C5?

How to Do Online Coding on Mercedes W205 with VXDIAG Benz C6 DoIP/ MB Star C4 C5? Note: If you want to support online programming,you must have an account online. Communication with control unit ‘N3/10 -Motor electronics ‘MED40’ for combustion engine ‘M274′(ME)’ is being established. Version information. Error codes. Actual values.

VXDIAG BENZ Star C6 Work Perfectly on Mercedes-Benz R300 & 221 ME9.7

VXDIAG XENTRY Diagnosis VCI is the latest interface for For Mercedes & SMART vehicles can replace Star C4/C5. VXDIAG For XENTRY Diagnosis VCI acts as a Pass-through Interface, also called Star C6, For Benz C6 multiplexer to provide complete communication between a vehicle and the VXDIAG For Xentry software loaded on