CGDI MB Program Old Benz K-line w202 w208 w210 Key via OBD

CGDI Prog MB software v2.8.1.0 adds Mercedes Benz old K-line vehicle key programming. Here’s the guide on adding new keys to w202 w208 w210 kline MB 38pin car from 1997 to 1998 via OBD.

CGDI-MB-Program-Old-Benz-K-line-1

Original car key

New key to be programmed

Procedure:

Step 1: Calculate Password
Connect CGDI Prog with laptop and vehicle
Open CGDI MB software

CGDI-MB-Program-Old-Benz-K-line-2

Go to EIS->Read EIS data

Select Computer Password-> Copy key with key-> Collect data

CGDI-MB-Program-Old-Benz-K-line-3

Select key type: Other keys
Follow 7 steps below to collect data
1.Insert original key into EIS and press OK

CGDI-MB-Program-Old-Benz-K-line-4

This is a k-line EIS, the operation is different from the ordinary EIS.

CGDI-MB-Program-Old-Benz-K-line-5

2.Insert key into CGDI MB and wait for collection
3.Insert the car key into EIS 10s and remove
Make sure to twise the key to ON position and turn on insturment. If failed to do this, pull ouit the ey
and try again. Press OK to continue.

CGDI-MB-Program-Old-Benz-K-line-6

4.Insert the key into EIS

CGDI-MB-Program-Old-Benz-K-line-7

5. Remove the key for 5s and then insert the key into EIS
6.Insert the key into CGDI MB
7. Save the generated files

CGDI-MB-Program-Old-Benz-K-line-8

Save the file successfully. Upload the data to calculate password.

CGDI-MB-Program-Old-Benz-K-line-9

Select Upload Data

Upload data just saved

CGDI-MB-Program-Old-Benz-K-line-10

Upload data successfully. Press Query Results to calculate pass

CGDI-MB-Program-Old-Benz-K-line-11

Calculate password success.

CGDI-MB-Program-Old-Benz-K-line-12

Copy and paste the pass to EIS Key password area

CGDI-MB-Program-Old-Benz-K-line-13

Save EIS data

Step 2: Generate EE

CGDI-MB-Program-Old-Benz-K-line-14

Select Generate EE->V051-> Load EIS file

CGDI-MB-Program-Old-Benz-K-line-15

Upload EIS file just saved

Press Generate Key File

CGDI-MB-Program-Old-Benz-K-line-16

The key file was generated successfully

Step 3: Write Key

Go to Read/Write Key->IR
Insert new key into CGDI Prog device

Press Read Key/Chip
Then Open/Write

Smart key choose 41 format, common key and BE key cchoose 51 format.

Select a key file

Write key success.

Test the new key. Works good.

Be the first to comment

Leave a Reply

Your email address will not be published.


*