China auto diagnostic tool center–About OBD2 Things:such as Launch X431,Autel tools,Autoboss
Tutorial: how to activate/register Xentry and update vxdiag benz multi tool vci firmware. The procedure can be applied to: VXDIAG Benz C6 doip OEM Benz C6 using VXDIAG solution Xentry DAS does not require activation. Ready to use. DTS Monaco engineer software requires USB connection with vxdiag c6 and laptop
Possible to change language in the Vxdiag Benz C6 WIS software? Yes, so does EPC. Check the easy guide below. The procedure is the same on vxdiag c6, vcx se benz and mb star sd c4/c5 devices. Change WIS software language: Run WIS, go to Options tab- Setup F2 – Langauge
Here’s the instruction to add SMR-d and Configure DTS Monaco engineering software for OEM Benz C6 DoIP VCI. Software HDD should be purchased alone (comes with keygen and DTS Monaco software). Add DTS Monaco SMR-d operation: Open DTS System Configurator on desktop, select Interfaces, right click to open new interface
Vxdiag Benz C6 03/2021 and later version Xentry hard drive has two xentry programs on the desktop- Offline XENTRY (Diagnosis) and Online XENTRY (Diagnosis). Which one to choose from? (Click to enlarge images) Offline XENTRY (Diagnosis): this option should be selected when you don’t have a Mercedes Benz online programming account.
VXDIAG For XENTRY Diagnosis VCI is the latest interface for For Mercedes & SMART vehicles can replace Star C4/C5. VXDIAG For XENTRY Diagnosis VCI acts as a Pass-through Interface, also called Star C6, For Vxdiag Benz C6 multiplexer to provide complete communication between a vehicle and the VXDIAG For XENTRY
I have seen a few people struggling with DoIP and VXDIAG C6. Please see the attached image of the interface settings for DoIP. When using DoIP with Vxdiag make sure you uncheck/turn off the CAN interface(MODULE_TYPE_ID_MTS6532) in DTS. Then connect the interface to the car and laptop, open vxmanager and
Problem: I recently got the Vxdiag Benz C6 XENTRY updated to 2019.05 version. It connects fine before but the VCI seems not cumminicate well after update. Error “VCI Cannot be Used. Firmware is older than the installed program version” error picture attached: Solution: The old Benz C6 VCI driver is not
How to Do Online Coding on Mercedes W205 with VXDIAG Benz C6 DoIP/ MB Star C4 C5? Note: If you want to support online programming,you must have an account online. Communication with control unit ‘N3/10 -Motor electronics ‘MED40’ for combustion engine ‘M274′(ME)’ is being established. Version information. Error codes. Actual values.