Autel IM608 Program Keys for Ford Fiesta PATS 2008

This instruction show you guide on how to useĀ Autel MaxiIM IM608 to program keys for Ford Fiesta PATS 2008.

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-1

Procedures:

Build connection build Autel IM608 device and Ford Fiesta,then enter Ford menu to select [Fiesta]

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-2

Select [2002-2008]

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-3

Select [Blade Key]

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-4

Select [Immobilizer(CAN)]

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-5

Select [Erase Key]

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-6

Note:All key will be earsed.At least 2 keys are required for key learning to complete,click [Yes] to continue

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-7

Turn the ignition to the ON position,click [OK]

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-8

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-9

After erase key complete,click [OK]

All known key has been erased,You must now program a minimum of two keys.

The engine will not start until you complete the following steps:
Perform the following steps to learn the ignition keys

Turn the ignition OFF

Turn the first key in the ignition to ON for 3 seconds,then remove

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-16

Would you like to add more keys?

Press [Yes] to continue,press [NO] to complete the procedures.

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-17
After finish all necessary functions,comfirm that all learned keys can start the engine.Verify that the engine continues to run for at least 5 seconds.

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-18

Learning completed.

Autel-IM608-Program-Keys-for-Ford-Fiesta-PATS-2008-19

Done!

Test the keys programmed on vehicle.

www.obd2tool.com

Be the first to comment

Leave a Reply

Your email address will not be published.


*